What went
well was that I was able to cut my flat on the styrene sheet using the Zun
machine. I was surprise and impress that I was able to use the machine by
myself without any assistance.
What did not
go well was that the machine did not cut completely through the sheet. It made
dented lines on the other side of the sheet, instead of cutting right through,
despite me getting adjusting the settings to make sure it cut right through the
sheet, it did not work out. This meant I had to go over the cut lines myself switching
between using the Stanley knife and a scalpel.
I will be
continuing to finish my model for Monday. I should also go to the 4D model shop
to buy figures for both of my models. Now I know how big my model is, I can now
buy my figures for my models.
No comments:
Post a Comment